聊天室整点发红包彩票

Tubes

amplifier This site contains an introduction to the basic concepts and mathematics, involved in Hi-Fi, tube amp building. A special emphasis is placed on the design of power supplies. The contents of the guide can be accessed via the navigation menu, and it will continue to be updated, expanded and maintained. The object of this site is to provide a solid, mathematical reference for tube amp builders. Comments, suggestions and criticisms may be sent to me in the contact聊天室整点发红包彩票 form - below.

Pictured above is the classic .

blog

01/05/17

聊天室整点发红包彩票 From the 1950s, a Basic Vacuum Tube Amplifier instructional video. For best results, watch it on .


11/08/16

Recently, the site has been updated: dead links pruned, corrections in the math chapter, CSS tweaks, etc.


08/08/15

Over the past few days, minimal changes have been made to the website's design. This site continues to be repaired, updated and maintained - despite the utter聊天室整点发红包彩票 lack of blog posts.


12/14/13

c3m聊天室整点发红包彩票 The pentode was engineered for long distance telephony - in a successful attempt to produce an ideal tube: high amplification factor, low noise, compact size, etc. It was designed with no compromises in design and construction: .

In the link below is a schematic for an SE 813 UL amp. A C3m (along with another tube) are wired-up in an SRPP configuration as a high gain/low noise driver to produce ~35W audio ouput in Class A1: .

However, a single, C3m volt amp should be able to generate the required 80V peak to run the control grid of an 813 in SE A1 - with an acceptable level of noise.


05/14/13

Recently, I've been experimenting with 813 rf tubes in triode mode, using "" as power-tube drivers. I figure that the audio output is ~35W in Class A2 per channel. If the interstages were not $100 a pop, a wicked amp could be produced on the (relatively) cheap. However, I suspect that the driver's power supply would produce an unacceptable level of noise without the interstages. The schematic from which the amp was derived is here.

Regarding the 813 amplifier, the voltage used to energize the plates is a whopping 900Vdc. If voltages in excess of 600Vdc are attempted, extreme caution is advised.

网赌输了的人都怎么样了 网赌输光了我的全部 网赌输十万心疼怎么办 网赌输了能慢慢回本吗 网赌输十几万了没有活路了 网赌输的一无所有想死 网赌输的居然赢回来了 网赌输第三次要坦白吗 网赌输钱会被拘留吗 网赌输惨了怎么上岸